DiyLightAnimation

Hardware => Lynx Express => Topic started by: mmais68569 on January 19, 2011,

Title: LE Heat Sinks
Post by: mmais68569 on January 19, 2011,

I am looking for a set of heat sinks for LE Ver.5 if you have an extra set or kno0w where I can get a set let me know.
         

      Thanks Mike
                               

Title: Re: LE Heat Sinks
Post by: memphislights on January 19, 2011,

PM RJ, if he doesn't have any right now, he should have a some over after he finishes the LE coop.

I think that he is pretty busy right now, so give him a few days to respond.

Title: Re: LE Heat Sinks
Post by: Asterix0 on January 19, 2011,

Me too!

Title: Re: LE Heat Sinks
Post by: RJ on January 19, 2011,

I am out right now but will have them after the coop ships.

RJ

Title: Re: LE Heat Sinks
Post by: WWNF911 on January 20, 2011,

I have a couple extra black ones.

Title: Re: LE Heat Sinks
Post by: CaptKirk on January 20, 2011,

I made my own out of a hunk of scrap extruded aluminum that was a bit too tall but was easily cut down to RJ's heat sync size.  Mine has the bend on the bottom to allow it to mount to the board (RJ- I used insulating washers on both the head side AND the spacer side against the board to prevent shorts) but is missing the top bend (or "handle" as RJ puts it in the assembly videos) and the laser etch.  Not bad for scrap and a Sawz-All cut job....