DiyLightAnimation

Hardware => Lynx USB DMX Dongle => Topic started by: Danbe on November 11, 2011,

Title: Can I programme my adaptor v2.0 for pixelnet to use with SSH
Post by: Danbe on November 11, 2011,

Can I programme to programmed my adaptor v2.0  (USB TO DMX )for pixelnet to use with SSH. I did some search but I didn't find nothing  If yes where I can find programmed?  Thank  Daniel :)

Title: Re: Can I programme my adaptor v2.0 for pixelnet to use with SSH
Post by: rrowan on November 11, 2011,

The firmware in the wiki is for Lynx hardware only. I am guessing the adaptor 2.0 is a clone of the dongle and if uses a different pic then the microchip then Nope

Rick R.

Title: Re: Can I programme my adaptor v2.0 for pixelnet to use with SSH
Post by: Danbe on November 11, 2011,

USB to DMX Adaptor V2.0 Make by Robert P. Martin  Power by vixen

Title: Re: Can I programme my adaptor v2.0 for pixelnet to use with SSH
Post by: keitha43 on November 11, 2011,

No it must be RJ's dongle.

Title: Re: Can I programme my adaptor v2.0 for pixelnet to use with SSH
Post by: rm357 on November 11, 2011,

You should contact the person that designed it or that you bought it from. Pixelnet is a simpler protocol to generate code for than DMX (none of that break generation/detection stuff). If the hardware is fast enough, writing firmware to generate pixelnet should not be a big issue. The pixelnet protocol is described in detail in the wiki.

RM