DiyLightAnimation
Hardware => Lynx MR16 / 16 CH DC Controller => Topic started by: frankr on November 09, 2012,
-
Hello all,
I finally finished 4 MR-16s I bought about 3 years ago. OF the four 2 worked perfect but 2 are giving me fits.
Problem one:
One unit works on Channels 1-16 but will not take a programmed address. I tried reflashing and got the same results.
Problem two:
This one just does nothing... I checked that I am getting 5 volts out of the 7805.
Not sure where to look from here. I need to take them out of my mounting to check solder joints next. What else should I be looking at?
Frank
-
OK, Problem 2 solved (voltage regulator working does not matter if there is no solder on the joint...) but now That unit has the same problem as unit 1. I can control the unit with channels 1-16 but cannot get it to take a new address.
OK Nevermind.... Now I have both working as expected....
Frank
-
Glad we could help ;D
Rick R.
-
<la..