DiyLightAnimation

Hardware => Lynx Express => Topic started by: joshuashu on November 11, 2012,

Title: no dmx
Post by: joshuashu on November 11, 2012,

I have a version 4 that is acting funny.  I am using and IDMX, cable is correct, i know it works cause i am using it via wireless.  when i go to test mode on the lynx with the cable plugged in, dmx light does not come up, if i unplug it and test again the dmx light will come on?  i can not control the light via the console on LOR?

Title: Re: no dmx
Post by: Jeffl on November 11, 2012,

The LOR console does not control DMX lights as of last year 2.9x.  Not sure if they fixed anything in the 3.x this year.  I use xlights for single controller testing and LOR to run the show.

Title: Re: no dmx
Post by: mmccrae on November 11, 2012,

I use LOR S3 3.7 it works great and it does run DMX native even with a lynx dongle. lynx network option was added in this years upgrade


Mike

Title: Re: no dmx
Post by: joshuashu on November 11, 2012,

i got it fixed,  the remove for wireless jumper was not working, so i pinched them together and it is working now.

Title: Re: no dmx
Post by: Jeffl on November 11, 2012,

Very odd. I would think you could get a jumper from any computer repair shop.  I have a number of them from old computers and hard drives, CD drives etc.

Title: Re: no dmx
Post by: JonB256 on November 12, 2012,

It is possible that one of your Remove for Wireless pins is unsoldered. Squeezing them just made the contact.

Never known a pin jumper to not work.