DiyLightAnimation
Hardware => Lynx Express => Topic started by: keithr on November 27, 2012,
-
Odd behavior. Have 4 LE v5 that on the bench all 16 out puts connected to 100 ct LED's; All works fine.
Place in the yard connect all 16 channels up and only half the controller works 1-8, no activity 9-16. Brought back all controllers and benched again all is fine.
I feel an elctrical germlin is at hand here, any help is most appreciated.
Seasons Greeting to All...
-
Do you have power going to both power input areas? 1-8 are on one power source and 9-16 are on the other.
Sent from my iPad using Tapatalk HD
-
I had this happen on a LOR setup I had with two controllers in it and half the boards were powered to each one. Talk about a headache. I had two power cords with a tripple tap on each with the power cords on the controllers swapped and one of the extension cords with a tripped GFCI.
I think I had a better chance of wining the lottery than having this happen.