DiyLightAnimation
Software => xlights => Topic started by: lorajoslyn on December 06, 2012,
-
I have just added some arches, and cannot get all of them to illuminate through xlights. Things I've checked:
1) Added lighting networks
Network Type Port E1.31 Univ Last Channel
E131 239.255.0.1 1 512
...
E131 239.255.0.16 16 512
Last channel for univ 16 is 8192, and my last channel on LSP is 7876
2) I added 8 arches, and xlights illuminates all but the last 3 arches (so, channels 6977-7876)
3) Went to test tab in xlights, and confirmed all the arches illuminate.
4) I'm using LSP, and the outputs work fine in the sequencer (all 8 light). I used light elf to convert the LSP to xseq for xlights.
5) The song I'm using does illuminate those lights in the LSP scheduler (but there's a huge lag so I can't use it)
Suggestions on where to look?
-
This has nothing to do with xlights, it had to do with my channel mis-labelling for my 2nd SS Hub. I erroneously programmed the SSCs on Hub 2 to my actual LSP channel, which were channels greater than 4096.
Interestingly enough,they did work, but at a lag at times, which is why it wasn't easy to diagnose. Re-programmed SSCs to channels 1-4096, on SS Hub 2, and we're good now.
-
See I knew we could help you figure it out <fp.
happy you got it working <res.
Rick R.