DiyLightAnimation

Hardware => Lynx Express => Topic started by: battle79 on December 22, 2012,

Title: Is the Lynx Express able to run DMX 240V outputs?
Post by: battle79 on December 22, 2012,

Hi All,

Just wanting to know if this board is capable of running 240V outputs in DMX?


Also can the SSR4 w/ DMX be modified by a resistor swap like most boards to run 240V?

The Express is drastically cheaper  then a LOR board, and the SSR4 w/DMX is cheaper again, so really hoping I can make use of these in Australia and same some money for the lights themselves.

Regards,
Rowan

Title: Re: Is the Lynx Express able to run DMX 240V outputs?
Post by: pk on December 22, 2012,

Appendix B of the Lynx Express assembly manual has the modification instructions for 240 VAC operation.

http://www.diylightanimation.com/wiki/index.php?title=Manual_Express#Appendix_B_240VAC_mod

Title: Re: Is the Lynx Express able to run DMX 240V outputs?
Post by: battle79 on December 22, 2012,

Cool thanks,

Ok so the express is good to go, now to find out about the SSR4.

Cheers,
Rowan

Title: Is the Lynx Express able to run DMX 240V outputs?
Post by: rm357 on December 23, 2012,

There is also an alternate firmware for 50hz operation. I'm thinking you will have to pm RJ to get it unless someone else forwards a copy to you.