DiyLightAnimation
Hardware => Lynx Smart String => Topic started by: Jimmy on May 15, 2014,
-
I have v2 SSC that was working great, while troubleshooting some bad nodes, I may have shorted leads. Anyway, SSC has no output, but LD1117 is very hot to touch. I'm I correct in assuming I fried the regulator?
Thanks
Jimmy
-
While possible, you may have fried the PIC. I would remove the PIC and see if the regulator still gets hot. If you managed to short the data line to the +12V lead, that can pretty much fry the PIC.
-
Thanks for advise. I'll pull PIC and go from there.