DiyLightAnimation

Hardware => Lynx Wireless DMX => Topic started by: i1uhrace on September 26, 2015,

Title: Powering the tx from an LOR header
Post by: i1uhrace on September 26, 2015,

I'm trying to power my wireless tx from the J0 header on an LOR board. It has a 5v output and was wondering if anyone knows if it'll run off 5v or if I need to use the 10v pin and put a small DC-DC voltage reducer in line to take it to 6v?

Title: Re: Powering the tx from an LOR header
Post by: i1uhrace on September 27, 2015,

Never mind I went ahead and tried it and it seems to work from the 5v.
Just need to run some test sequences to be for sure.

Title: Re: Powering the tx from an LOR header
Post by: i1uhrace on November 22, 2015,

I ended up having to move it to the 9vdc pin but so far so good.