DiyLightAnimation

Hardware => Lynx SSR4 => Topic started by: onesmoothhead on November 20, 2016,

Title: zues 8 won't run off active hub
Post by: onesmoothhead on November 20, 2016,

Heelo, quick question, my Zues 8bis set to channel 4097. I am feeding pixel net signal from an active hub. I test mode it will test fine, but in show mode I get nothing on my zues mega tree. Any ideas?

Title: Re: zues 8 won't run off active hub
Post by: tbone321 on November 20, 2016,

A PixelNet universe only has 4096 channels so setting it to 4097 is not a valid address.  Show channel 4097 would be Universe 2 Channel 1 in PixelNet terms.  Also a Zeus does not connect to an active hub controller output and doing so would damage the Zeus.  Make sure that the Zeus is only connected to a full PixelNet output.

Title: Re: zues 8 won't run off active hub
Post by: onesmoothhead on November 20, 2016,

It is on a pixenet output. I should have been more clear. It turns out I had xLights model set incorrect. It works like a charm on Universe 2. Thanks as always.