DiyLightAnimation

Hardware => Lynx Splitter => Topic started by: OkieJay on December 07, 2009,

Title: Can someone point me to some details on the 4th output port splitter issue?
Post by: OkieJay on December 07, 2009,

I THINK I have looked at every thread in the Splitter and Troubleshooting sections as well as doing searches.  I have found mention of the issue but no details. 

Thanks,
Jay
 

Title: Re: Can someone point me to some details on the 4th output port splitter issue?
Post by: rrowan on December 07, 2009,

Hi Jay,

Its suggested not to use all 4 ports. I believe the on-board transformer is not large enough to handle the current required. Ver 2 of the splitter now only has 3 ports on it. It can cause flickering and in some cases a ssr4-dmx not to work. I think it was talked about in the ssr4 forum last year.

The above info is just from memory and I might be wrong about the current and transformer.

Rick R.

Title: Re: Can someone point me to some details on the 4th output port splitter issue?
Post by: blickensderfer on December 07, 2009,

Jay,

Check out the wiki..  It has the fix for the spliter in the manual.

http://diylightanimation.com/wiki/index.php?title=Manual_Splitter

Title: Re: Can someone point me to some details on the 4th output port splitter issue?
Post by: ThaiWay on December 07, 2009,

My Splitter has no version number; just Robert Jordan {c}2008.

Is this Version 1?

John

Title: Re: Can someone point me to some details on the 4th output port splitter issue?
Post by: blickensderfer on December 07, 2009,

John,

I believe it is..  Mine doesn't have a version number and I got mine in the very first coop.  I had to put the jumper in for the 4th output and it worked like a charm.

Dan

Title: Re: Can someone point me to some details on the 4th output port splitter issue?
Post by: WWNF911 on December 09, 2009,

Thanks for bringing this up. Reminded me that I needed to address this issue and now, hopefully, I have the fix.  :)