DiyLightAnimation

Hardware => Lynx MR16 / 16 CH DC Controller => Topic started by: Randy_A on September 07, 2010,

Title: Constant Current
Post by: Randy_A on September 07, 2010,

So I don't screw something up. To run constant current you leave off the caps and resistors above the mosfets, jumper the oval holes where the caps would go in. Am I understanding the wiki correct??   ???

Thanks,
Randy

Title: Re: Constant Current
Post by: RJ on September 07, 2010,

Yes. this gets you constant current based on the resistor you put in the current limiter resistor spot.

RJ