DiyLightAnimation
Hardware => Lynx Express => Topic started by: fertsy on November 03, 2010,
-
I think I have everything in Vixen set up right
(https://lh4.googleusercontent.com/RxgxHxKnD_XwmgEBNmXLlI0VO5wY9pIABDefLhDhTzL2ljnxI5LOd7yMR4f4Yu86AVHl4Exij76nlqa2fYJmtFVd8g=s512)
I had my dongle programmed and tested fine on someone elses Express
I installed the Dongle drivers and know it to be on Com 4
I have tried 2 USB cords, neither of them new but one does say 2.0 on it.
I have tried 4 Ethernet cords
Any ideas?
I have a question about the terminate jumper on the v3 is it supposed to be on both pins? right now it is on the left pin only. I am not using wirless nor is a module hooked up.
-
Got it working. Seems it was noting a reboot and an unplug of the USB and replug couldn't handle. Thanks KeithTarpley for your support on teamspeak.