DiyLightAnimation

Hardware => Lynx Splitter => Topic started by: RJ on June 26, 2008,

Title: Lynx Splitter Info
Post by: RJ on June 26, 2008,
The Lynx Splitter is a DMX splitter that allows you to run you DMX a little more efficent in some cases. When laying out your christmas lights some times from the point where you're computer is, it would be nice to run in different directions to save total cable runs and clean up youre display.

It takes in you DMX signal and allows 4 outputs. The orignal signal to continue on and three new DMX signals with the full 32 device capacity to use. If you use any outputs you need to terminate the last device on each of the output runs. This is normal just putting the terminate DMX jumper in place on Lynx controllers and other devices.

RJ