DiyLightAnimation

Hardware => Lynx Wireless DMX => Topic started by: TexasStingray on January 20, 2011,

Title: Wireless Help
Post by: TexasStingray on January 20, 2011,

Ok, I have tried looking to determine what components I need to go wireless but am not sure looking at the equipment page. So let me begin by telling you what I want to do and maybe you could help with the right equipment. Is 'Wireless(TX/RX)Ver 2' a transmitter, receiver, or both.

#1 computer > usb > dongle > cable > ? (wireless transmitter not sure which component 'Transmitter (TX) Ver 1' or 'Wireless(TX/RX)Ver 2' )

#2 LE with Express Receiver (EX/RX)Ver 2 > ? (wireless transmitter for neighbors universe not sure what component so he could sync up)


Thanks
Scott

Title: Re: Wireless Help
Post by: Randy_A on January 20, 2011,

Scott,

Have a look here.. This should help you figure out some things. The Version 2 tx/rx can be either. Selected by the jumper setting.


Hope this helps out some..

Randy

Title: Re: Wireless Help
Post by: tbone321 on January 20, 2011,

The Ver2 units are all that are available now.  The Tx/Rx unit can be either a transmitter or receiver depending on how you configure it and can switch modes simply by moving a jumper.  If you already have the Ex/Rx unit then make sure that it is flashed with the VER 2 compatable firmware.  As for the neighbors universe, you can use the ver 2 Tx/Rx but who is controlling the universe? 

Title: Re: Wireless Help
Post by: TexasStingray on January 20, 2011,

Thanks.

I do not have any wireless components just trying to determine what I need. Do they have coops for the wireless components?

Title: Re: Wireless Help
Post by: tbone321 on January 20, 2011,

Yes they do although I don't know when the next one will happen.