DiyLightAnimation

Hardware => Lynx MR16 / 16 CH DC Controller => Topic started by: pwalstead on March 22, 2011,

Title: COOP
Post by: pwalstead on March 22, 2011,

Any one thinking of running a COOP some time soon? >.d9

Title: Re: COOP
Post by: trekster on March 22, 2011,

http://diylightanimation.com/index.php?topic=4697.0  The pole has it at 6%.  Last year I saw only one coop.  If you need one, DLA Store about a PCB (if he has one) and you can order the parts from Mouser.

Ron

Title: Re: COOP
Post by: chrisatpsu on March 22, 2011,

in January i was able to pick up a pcb for a MR16.  I'm almost done with it :)

Title: Re: COOP
Post by: fjaust on March 23, 2011,

i hope this comes about !! i'd be really interested in just a PCB only co-op. the mr16 is the perfect size for my needs and voltage requirements.

Title: Re: COOP
Post by: rm357 on March 23, 2011,

RJ is the source for most of the circuit boards used on this site. When a coop is run, he usually orders extra boards that will be available on a first come, first serverd basis after the coop orders have been filled.

Just check the DLA Store to see what is available and the cost.

Good luck!
RM

Title: Re: COOP
Post by: fjaust on March 24, 2011,

i did that already but didn't get a reply so i just assumed there were none left in stock. since then i think i've read somewhere that RJ hasn't much of any pcb's left in stock except for SSR's.

Title: Re: COOP
Post by: deanathpc on March 24, 2011,

Even the SSR4's are limited.  I got 5 pcb's from him but he is running low on those as well.