DiyLightAnimation

Hardware => Lynx Splitter => Topic started by: tng5737 on June 03, 2011,

Title: Can you use the Splitter with Pixelnet?
Post by: tng5737 on June 03, 2011,

Could the Splitter be used with Pixelnet?    I think the splitter is just RS485 - shouldn't care whether it is dmx or Pixelnet.  I was think of splitting the signal right after the Pixel Dongle with one path going to each hub.  The hubs are at either end of the house and the splitter is more or less halfway between the two.

Title: Re: Can you use the Splitter with Pixelnet?
Post by: RJ on June 03, 2011,

For a Dongle it should work but for the EtherDongle this would not work.

RJ