DiyLightAnimation

Hardware => Lynx USB DMX Dongle => Topic started by: wrxin on November 01, 2011,

Title: Pickit 2 ICSP adapter for the PIC used in the dongle
Post by: wrxin on November 01, 2011,

I have a pickit2 but no adapters for the bare chips. I'd appreciate any advice about how to program the PIC used in the dongle. I saw a bunch on J1 systems ( I think I have that right) but I'm not sure I they will work, which one to get, and how to use it?

Thanks!

Title: Re: Pickit 2 ICSP adapter for the PIC used in the dongle
Post by: rrowan on November 01, 2011,

This will work fine

http://www.ebay.com/itm/ICSP-Adapter-ZIF-28-pin-PIC-use-PICkit-2-3-/230432414015?pt=LH_DefaultDomain_0&hash=item35a6d7993f#ht_1522wt_1135

Just plug your pickit2 into it and the dongle pic. Set jumpers on L

Download hex file from wiki and import into Pickit Utility
Write hex code
All done

Rick R.

Title: Re: Pickit 2 ICSP adapter for the PIC used in the dongle
Post by: wrxin on November 01, 2011,

Wow thank you very much for the quick helpful response. I'm on it!

Title: Re: Pickit 2 ICSP adapter for the PIC used in the dongle
Post by: wrxin on November 01, 2011,

Sorry one last question. The jumpers go on the locations with just the singular letter L or on all the locations where an L is present? I can see two spots with a singular L and 4 more with an L and other letters.

Title: Re: Pickit 2 ICSP adapter for the PIC used in the dongle
Post by: lortiz on November 01, 2011,

Hi,

Jumpers go in all locations where you see the letter L.

Leo