DiyLightAnimation
Hardware => Lynx Express => Topic started by: joatman66 on November 19, 2011,
-
I have two LE's built so far. Both self test fine, but haven't actually ran them live.
After building the two and starting to work on a Lynx Wireless DMX Tx/Rx v2 board, I found that I inadvertently installed 25v 100uf Caps in the LE's instead of the 35v 100uf Caps as per the BOM.
I know they are spec'd for a reason, but is the swap going to effect operation? No biggie to pull them, but I I don't have to, I'll leave them. Conversely, can I use the 35v 100uf Caps in the Tx/Rx board?
Thanks!
-Aaron
-
Im thinking as long as you dont go over the voltage of a capacitor it should work fine. Think of a capacitor as a battery, there fine if they are charged below there rating, but can be ruined if overly charged.
-
The orignal part number for the caps on the LE were 25V (140-XRL25V100-RC). They switched to the 35V part number because the orginal ones were no longer available.
So, you don't need to change them.