DiyLightAnimation

Hardware => Bobcat DMX Tester => Topic started by: chrisatpsu on March 08, 2012,

Title: wireless module
Post by: chrisatpsu on March 08, 2012,
I'm thinking it should operate, but just want to make sure first.

Is the wireless module needed for wired usage? Otherwords, until i build that part, can i use the rest of the tester without it?
Title: Re: wireless module
Post by: combustionmark on March 08, 2012,
Will work wired. Just set mode switch to wired.

have fun
Title: Re: wireless module
Post by: n1ist on March 08, 2012,
It will work fine without the wireless module.
/mike
Title: Re: wireless module
Post by: kj77rn on April 14, 2012,
I have quite a few 4.7k ohm carbon film resistors.  Will they work in the wireless receiver or do I need the 4.75 k ohm metal film resistors?  I have all the other parts and was trying to save a Mouser order.
Title: Re: wireless module
Post by: dlhoppe on April 15, 2012,
I'm thinking it will work fine. However, I've never tried them as alternates myself.
Title: Re: wireless module
Post by: n1ist on April 16, 2012,
It will work fine.  I tend to think in terms of 1% resistor values.  In this case (they are either pullups or pulldowns), you could use any close value you have on hand.  Carbon film, metal film, or even old carbon composition ones are all OK
/mike
Title: Re: wireless module
Post by: kj77rn on April 17, 2012,
Thanks.