DiyLightAnimation

Hardware => Bobcat DMX Servo Controller => Topic started by: RickeyS on March 31, 2012,

Title: Can't program Pic?
Post by: RickeyS on March 31, 2012,

Hey everyone, I built my Bobcat servo controller but can't program the PIC, I thought maybe got a bad PIC but ordered two more PICs and still can't get them programed. I'm using a PICkit 2. I even tried to program them with the J1sys board with jumpers set to L and still says no device found. When I first start the software if finds the PICKit 2 but won't find the PIC18F23K20 to be able to program it. Any help would be appricated.
I have been able to program PICs for LE's, wireless etc. Just can't get this PIC programed. Must be doing something wrong. Please help
Thanks,
Rick

Title: Re: Can't program Pic?
Post by: RickeyS on March 31, 2012,

Never Mind, I got it, my pic program was still 2.50 which didn't support PIC, updated to the newest firmware 2.61 and was able to program PIC

Rick