DiyLightAnimation
Forum Info => Getting started with Light Animation => Topic started by: lashbyrn on August 14, 2012,
-
I just received my shipment of 6 CG 1500 enclosures from WLC. I was surprised to find out that only 1 screw hole on the Lynx express PCB would line up with the 76 mounting bosses provided in the cases. Looks like i will be making adapter plates. Any ideas on doing that?
-
I made some 1/4" strips of wood that are an inch and a half wide and covered the tops of the screws that I used to hold them in place with electrical tape.
-
I drilled through the back of the case and mounted a bolt, then on the inside I used a nut on each side of the board to lock it in place. I may have a picture somewhere, I will have to look.
-
the manufaturer of the enclosures make changes to the enclosures to changing specifications in the telephone and cable industries. you have the new design.