DiyLightAnimation

Hardware => Lynx EtherDongle => Lynx Conductor => Topic started by: tbone321 on November 05, 2012,

Title: Conductor Template
Post by: tbone321 on November 05, 2012,

Is there going to be a template available to make the cut in the side of the EtherDongle case for the memory card?

Title: Re: Conductor Template
Post by: dearvbguru on November 05, 2012,

I cut out my first one tonight to get it to fit and was a little big to make sure I could see exactly where the cuts need to be.

I will make the cuts on my second one probably tomorrow and if my template is good, i can make it and or the dimensions available.

Title: Re: Conductor Template
Post by: bassmants on November 05, 2012,

That would be great!

Title: Re: Conductor Template
Post by: complacent_one on November 06, 2012,

Is a template truly necessary??  It took about 30 seconds to lay out the lines, 1 minute to scribe them, and another 30 seconds to pull out the material.

I can see it you are building 20 of them how it would be useful, but if you are just building one....???

Title: Re: Conductor Template
Post by: rdebolt on November 06, 2012,

You are not allowed to view links. Register or Login

It took about 30 seconds to lay out the lines, 1 minute to scribe them, and another 30 seconds to pull out the material.

What are you using to "pull out the material"?

Title: Re: Conductor Template
Post by: complacent_one on November 06, 2012,

Uni-bit, drilling a half inch hole in the middle then use a pair of pliers to break the poly at the scribe lines...it can be pulled with the pliers after that.

Title: Re: Conductor Template
Post by: zwiller on November 06, 2012,

 <np..

Pics please. 

Title: Re: Conductor Template
Post by: complacent_one on November 06, 2012,

^  I agree...it is fairly worthless without photos.  I will add some this evening when I get back home this evening.

I have added a sketchup image that shows what I am talking about....I will add actual photo when I get home from work

(http://i94.photobucket.com/albums/l85/schwarz505/IMAG0306.jpg)
(http://i94.photobucket.com/albums/l85/schwarz505/IMAG0307.jpg)
(http://i94.photobucket.com/albums/l85/schwarz505/IMAG0308.jpg)

Title: Re: Conductor Template
Post by: JonB256 on November 06, 2012,

well, I was considering a smaller, separate hole for the ICSP pins but that would work!