Recent Posts

Pages: 1 2 3 4 5 6 7 8 9 [10]
91
Lynx MR16 / 16 CH DC Controller / MR16 For Sale
« Last post by mmais68569 on December 15, 2017,  »
I was digging through some stuff & found 3 never used MR16 DC controllers. If I remember correctly the pics have been programmed but I was never able to set the start channel & just set them aside. 
 I will sell for $50 each & I will throw in 16-2 core waterproof connectors.
Shipping will be as follows 1 board & connectors small flat rate priority mail
                                       2 or more with connectors med. flat rate priority mail.
Send me a PM if interested.
 PayPal OK US shipping only.
Thanks Mike
92
Sale/Trade / Re: Want to buy or trade Lynx USB DMX dongle
« Last post by koropuxa on December 15, 2017,  »
Got one on the way. Thanks
93
Sale/Trade / Re: For Sale Ether Dongles
« Last post by oldcaptainrusty on December 15, 2017,  »
Check your pm.
94
Sale/Trade / Re: Want to buy or trade Lynx USB DMX dongle
« Last post by koropuxa on December 14, 2017,  »
Thanks! PM and Email sent.
95
Sale/Trade / Re: Want to buy or trade Lynx USB DMX dongle
« Last post by loveroflife96 on December 14, 2017,  »
I have a PCB with parts kit...let me know if you're still looking....
96
Sale/Trade / Re: Ether Dongle Kit unbuilt
« Last post by trekster on December 12, 2017,  »
bump
97
Sale/Trade / Re: Zeus 16 channel unbuilt kit
« Last post by trekster on December 12, 2017,  »
bump
98
Sale/Trade / Want to buy or trade Lynx USB DMX dongle
« Last post by koropuxa on December 11, 2017,  »
Hello everyone,
Need help, real bad, actually.
I have all my Christmas lights setup and ready to go, however I cannot find my USB dongle. It got lost, most likely during the move.
I would love to buy a kit or assembled dongle.
I have a few Lynx Express PCB''s with heats sinks if anyone is interested to trade.
I would also consider buying just a Lynx dongle PCB.
Really appreciate it.
99
Lynx EtherDongle / Re: Unicast Support
« Last post by CaptainMurdoch on December 11, 2017,  »
In FPP, try setting your E1.31 interface to eth0 and your etherdongle universes to multicast, then add in a unicast universe pointed to an interface on the wifi network.  I have not tested that scenario before but it might work.
100
Lynx EtherDongle / Unicast Support
« Last post by lboucher on December 10, 2017,  »
Hi All

I want to send just a few channels out over wireless. I understand that if I go unicast, I can limit the amount of data going out over wireless. It looks like the etherdongle doesn't support unicast though.

I think the only thing I need to do is be able to set the ip address.

Is the source to the firmware available so I can set an ip? Or is there another way.

Thanks.
Pages: 1 2 3 4 5 6 7 8 9 [10]