OK, that makes me feel kind of better, now lets figure out why this isn't working...HAHA
I should have said I am trying to use the iDMX to control a DMX yoke light. Everyhing works fine cabled up, now I want to switch over to wireles...simply because its cooler. Assuming that the wireless units are fine, which I believe they are, what could be the issue? Honestly I think it is a cabling issue. I looked on the WIKI for the wiring of the cables but am completely lose because their are so many.
Here is what I have done:
XLR connector coming out of the iDMX has the Orange wire soldered to pin #2
White/Orange wire is soldered to pin #3
Brown and white/brown are soldered to pin # 1
I then have the cat 5 connector wired as a "B" standard.
I have done the same thing for the receiver end going into the DMX light.
Is that correct?