Ssc and LE

[mitch09]

When setting up LSP with Etherdongle and Active Hub I cannot get any output to my SSC. I can program the SSC with Etherdongle-Active Hub and get all the lights to flash showing that they are programmed. I program the SSC with starting channel of 513 since I am using DmX with some LEs as well. In LSP I start my SSC at channel 513 and then run test controller hardware. No blinky. Output configured to pixelnet. I have also tried e131 over DMX. Neither works. What am I doing wrong?

Ryan

[urthegman]

If you are using the etherdongle, then your protocol should be e131 over Ethernet. Did you right click on the controller and attempt to configure the controller output plugin? You have to click on the Act button(activate) set the universe, the starting channel,and your universe size and set the destination to multicast. In v2.5 you can choose etherdongle presets but you still have to make sure you have the act boxes checked.