« previous next »
Pages: [1]

Author Topic: New etherdongle and conductor firmware programming.  (Read 1137 times)

Offline sittinguphigh

  • Sr. Member
  • ****
  • Posts: 679
New etherdongle and conductor firmware programming.
« on: November 25, 2012, »
I just built my etherdongle and conductor. Ready to connect the two. Do I program the etherdongle before or after I 
I connect the two.
Logged
What you don't know. Can hurt you.

Offline dpitts

  • Restrictive
  • Sr. Member
  • *
  • Posts: 466
Re: New etherdongle and conductor firmware programming.
« Reply #1 on: November 25, 2012, »
It does not matter.
Logged

Offline sittinguphigh

  • Sr. Member
  • ****
  • Posts: 679
Re: New etherdongle and conductor firmware programming.
« Reply #2 on: November 25, 2012, »
Thanks

Mort
Logged
What you don't know. Can hurt you.

Offline tbone321

  • Sr. Member
  • ****
  • Posts: 4055
Re: New etherdongle and conductor firmware programming.
« Reply #3 on: November 25, 2012, »
it is easier to connect the Programmer before you connect the two together but as said, it doesn't matter otherwise.
Logged
If at first you don't succeed,
your not cut out for sky diving

Offline keitha43

  • Sr. Member
  • ****
  • Posts: 1182
Re: New etherdongle and conductor firmware programming.
« Reply #4 on: November 25, 2012, »
What I did was test my etherdongle first using its firmware to make sure it was working 100% before reflashing with conductor firmware and testing that.

Sent from my Thunderbolt using Tapatalk 2.

Logged
Pages: [1]
« previous next »