I have an ED I built... I am having a lot of issues with it. The solder joints on the surface mounted chips where not soldered very well and I could not get the PIC to program. I have resoldered these joints but in the process I think I tore one of the traces on the smaller chip (not the PIC). The trace goes under the chip so I dont know where to other end goes to check continuity.
I was able to finally get the PIC to program and the magic jack has the green LED on and the Yellow one will flash occasionally but it does not seem to be communicating with vixen (yes I have selected the output plug in).
I will start another thread to discuss the other issues, but I wanted to see if there was a pic available of the board without the surface mount chips so I can check continuities.
