Author Topic: Power jack does not fit  (Read 1149 times)

Offline jnealand

  • Patron Member
  • Sr. Member
  • ****
  • Posts: 2494
Power jack does not fit
« on: December 03, 2013, »
Got my first ETD from the last coop almost finished.  However the power connector studs do not fit thru the holes on the board.  I have not seen anyone else mention this.  I have slowly been shaving down the posts to make them smaller, but still have more to do.  This is my 3rd ETD and the two I built last year never had this problem.  Has anyone else seen this occur, I have not seen it mentioned on the forum?
Jim Nealand
Kennesaw, GA

Offline dearvbguru

  • Full Member
  • ***
  • Posts: 65
Re: Power jack does not fit
« Reply #1 on: December 03, 2013, »
I mentioned it in last years etd coop. I had to snip the leads on all of mine in order to get them to fit through the holes. Just solder it good and you will be fine

Offline keitha43

  • Sr. Member
  • ****
  • Posts: 1182
Re: Power jack does not fit
« Reply #2 on: December 03, 2013, »
That what I did a couple years ago.