« previous next »
Pages: [1]

Author Topic: Any way to quickly flash the Etherdongle PIC without a full build ?  (Read 1204 times)

Offline taybrynn

  • Sr. Member
  • ****
  • Posts: 2042
    • RockinChristmas
Any way to quickly flash the Etherdongle PIC without a full build ?
« on: December 20, 2013, »
I have a pickit3 for a couple more hours -- is there any way to do a quickie flash without building out the whole board first?

I installed the ISPF header and was wondering if anyone knew what the minimum would be to flash the PIC or if thats even advisable at all.

THanks,
Scott
Logged
Scott - Castle Rock, Colorado   [ 2 homes, 100% RGB in 2016; since 2008; over 32k channels of E1.31 ]
You are not allowed to view links. Register or Login

Offline rm357

  • Sr. Member
  • ****
  • Posts: 1282
  • 31088
Re: Any way to quickly flash the Etherdongle PIC without a full build ?
« Reply #1 on: December 20, 2013, »
Probably too slow on the response, but it would try it with just the header. You might need a capacitor and/or a resistor or two. Since the pickit provides power to the pic, the programming circuit is usually very simple.
Logged
Robert
Warner Robins, Georgia, USA

Offline RJ

  • Administrator
  • Sr. Member
  • *****
  • Posts: 8519
Re: Any way to quickly flash the Etherdongle PIC without a full build ?
« Reply #2 on: December 20, 2013, »
one of the small caps near the pic is required.

RJ
Logged
Innovation beats imitation - and it's more satisfying
Pages: [1]
« previous next »