***********CLOSED Lynx Wireless Parts Only Kit Co-Op**************

[31swford]

Thanks for doing this. Let me place my order before you change your mind! Rhonda
Kit #2-  1 transmitter
Kit #3-  3 receivers

[Ron]

Bill, put me down for:

Kit #1 - 10
Kit #2 - 1
Kit #3 - 2
Kit #4 - 10

Thanks.

Ron

[abell]

Can you please adjust mine:

Kit #1 +3
Kit #3 -2

New Totals:

Kit #1 = 8
Kit #2 = 1
Kit #3 = 3

[grossg]

Bill,

Will you please put me down for:

Kit #1 Qty 12
Kit #2 Qty 2
Kit #4 Qty 2

Best regards and thanks for all your help!
Glen

[KeithTarpley]

Greetings,,,

Please put me down for:

Kit #1 - 30          Lynx Express Receiver
Kit #2 -   6          Transmitter
Kit #3 -   2          Stand Alone Receiver
Kit #4 -  50         RS485 DIP socket connector

Thanks, Bill

Keith

[Brad]

Bill,

I need,
Kit #1 = 2 EX/RX
Kit #2 = 1 TX
Kit #3 = 1 RX

Brad

[REM]

Please add the following to my existing order:

Kit #1: 5

Thanks! --Ron

[PJNMCT]

The three choices to order are :


Kit #4 RS485 DIP socket connector (This module will plug into the RS485 socket that will allow the LE receiver to be used with the other Lynx controllers)
Basically you can add wireless to the Original Lynx, SSR4, FreeStyle, MR16.

Bill,

I'm trying to understand why I need any stand alone receivers if I can just use an LE receiver and this connector. Any info?

Thanks,
- Paul

[RJ]

The three choices to order are :


Kit #4 RS485 DIP socket connector (This module will plug into the RS485 socket that will allow the LE receiver to be used with the other Lynx controllers)
Basically you can add wireless to the Original Lynx, SSR4, FreeStyle, MR16.

Bill,

I'm trying to understand why I need any stand alone receivers if I can just use an LE receiver and this connector. Any info?

Thanks,
- Paul

You might not.
First the Range on the Standalone will be farther than the EX/RX. Also other Equipment like LOR, ETC. you should use the standalone.

Also hacking a LE/RX does not give for a clean install so you might want a cleaner install.

You also can not daisy chain any other piece of equipmwnt off of this setup so you might want to use one standalone and run a whole chain of SSR4's with DMX like me for another.

RJ

RJ

[PJNMCT]

So RJ,

I just updated the wiki: Equipment Errata - Dimmer comparison table.

Is the wireless pkg column correct?

Thanks,
-Paul

[RJ]

Looks right to me!

RJ

[PJNMCT]

Bill,

Please revise my request to

#1 - 10
#2 - 2
#3 - 2
#4 - 10

Thanks,
-Paul

[WWNF911]

Bill,

Please revise my number count to the following:

#1 - 10
#2 - 2
#3 - 3
#4 - 10

Thanks,
Leon

[lonewolf41]

OK, lets start out with this.  May need more later, but I'll deal with it then...or update my total if the coop is still open.

Kit #1 (LE RX) - Need 5
Kit #2 (TX) - Need 1

Thanks,
-Keith

[jnealand]

Bill I would like the following
Kit 1 - 2
Kit 2 - 1
Kit 3 - 2
Kit 4 - 8

Thanks
Jim Nealand