Hardware > Lynx MR16 / 16 CH DC Controller

Problem Programming PIC firmware on MR-16

<< < (2/2)

rrowan:
You could try this page instead of the page you did use

You are not allowed to view links. Register or Login

no resistor needed just the .1uf cap across the pins 5 & 14 of the PIC

Also in the FAQ here is the link for all of the pic pages You are not allowed to view links. Register or Login

Rick R.

plaberge:
You are not allowed to view links. Register or LoginYou could try this page instead of the page you did use

You are not allowed to view links. Register or Login

no resistor needed just the .1uf cap across the pins 5 & 14 of the PIC

Also in the FAQ here is the link for all of the pic pages You are not allowed to view links. Register or Login

Rick R.

--- End quote ---

Thanks for pointing those pages out Rick. Not sure how I missed them! I think I went down a rat hole because of the title of the original page that I looked at refers to a PIC18F but is for a different device and I didn't think there was a specific page for the Pic18f1220.

Turns out I won't need to program using a breadboard right now. With packetbob's help (and his DIP adapter) I was able to get it programmed. All good for now :)

Navigation

[0] Message Index

[*] Previous page