Software > Vixen

output plugin error

(1/2) > >>

ElectricCraft1:
getting a router output error at end of my first sequence in my program. it ends the program and wont let me run anything else unless ui restart vixen.  already changed com ports.  any ideas

memphislights:
unchecked off DMX in the add-ins drop down menu?

also, what comm port are you using?

rrowan:
Hi EC

My first suggestion to try and I know you are going to think I am crazy or worse

Try Different USB Cables (I went through 4 cables before it worked well for me)

I would also try clicking on the menu bar
Tools
 Preference
  Sequence Execution
   (either Check or UnCheck) Reset Controller at the end of the Sequence

Rick R.

I forgot to say to check and see if you have the latest version of the FTDI drivers. The link to it is in the wiki software page at the bottom. If you do update MAKE sure you update both the com port and usb bus drivers included in the file on their site.

ElectricCraft1:
unchecked and com 9, also tried com 10.  Ill try the suggestions.  Should I use the settings for the sequences or the program?

rrowan:
Wait

Are you just running a sequence in Vixen or are you running a Scheduled Program?

If the latter then you should flatten out the sequence. (No profile, no attached plugins)

Then use the profile setting for the program

Make sure the cross over is zero

Rick R.

Navigation

[0] Message Index

[#] Next page