Hardware > Lynx Wireless DMX
Powering the tx from an LOR header
(1/1)
i1uhrace:
I'm trying to power my wireless tx from the J0 header on an LOR board. It has a 5v output and was wondering if anyone knows if it'll run off 5v or if I need to use the 10v pin and put a small DC-DC voltage reducer in line to take it to 6v?
i1uhrace:
Never mind I went ahead and tried it and it seems to work from the 5v.
Just need to run some test sequences to be for sure.
i1uhrace:
I ended up having to move it to the 9vdc pin but so far so good.
Navigation
[0] Message Index
Go to full version