Author Topic: Powering the tx from an LOR header  (Read 2167 times)

Offline i1uhrace

  • Full Member
  • ***
  • Posts: 87
Powering the tx from an LOR header
« on: September 26, 2015, »
I'm trying to power my wireless tx from the J0 header on an LOR board. It has a 5v output and was wondering if anyone knows if it'll run off 5v or if I need to use the 10v pin and put a small DC-DC voltage reducer in line to take it to 6v?
Carnation Christmas

Offline i1uhrace

  • Full Member
  • ***
  • Posts: 87
Re: Powering the tx from an LOR header
« Reply #1 on: September 27, 2015, »
Never mind I went ahead and tried it and it seems to work from the 5v.
Just need to run some test sequences to be for sure.
Carnation Christmas

Offline i1uhrace

  • Full Member
  • ***
  • Posts: 87
Re: Powering the tx from an LOR header
« Reply #2 on: November 22, 2015, »
I ended up having to move it to the 9vdc pin but so far so good.
Carnation Christmas