Hardware > Lynx EtherDongle
I Know, I know, not another "my etherdongle won't program" thread
(1/1)
rrawlings:
I have my completed etherdongle that I finally built from the 1st co-op. I sourced the correct 49.9ohm resistors and assembled. I am coming up with an error upon trying to program. I am getting the message "Ensure proper capacitance on VDDCORE/VCAP pin. This is pin 85 on the PIC chip. I have checked the capacitors and have the correct 0.1 uf and 10.0 uf capacitors from ground to pin 85. Am I missing some big thing here or is there a chance that I have a damaged PIC chip? any help would be appreciated.
tbone321:
You may want to post a close up picture of the board.
rrawlings:
I can assure those who are willing to help that it is assembled correctly, having managed an electronic manufacturing company for nearly 20 years. I am hoping someone else has encountered this same error.
Jeffl:
Not sure I'm going to be of much help but what are you using to program it with?
KevinHolme:
I remember getting that error message, I dont remember with what programmer, but I do not think it is hardware.
Try my last post in the post right before you. You are not allowed to view links.
Register or Login
Hope it helps.
Navigation
[0] Message Index
Go to full version