Author Topic: Getting the MR16 going....  (Read 3739 times)

Offline Jasonlnlv

  • Sr. Member
  • ****
  • Posts: 153
Getting the MR16 going....
« on: December 16, 2015, »
I have setup and got the MR16 I got years ago installed in a box and running - I just used the Lynx Address utility to set it to start at channel 65 it all looked ok - is there a way to check this - before I run all the led floods and it not be right and have to TS outdoors?? Is there a software to check the Dax start address?

Thanks

Offline packetbob

  • Sr. Member
  • ****
  • Posts: 130
    • zappedmyself.com
Re: Getting the MR16 going....
« Reply #1 on: December 16, 2015, »
You can generate a test pattern in Vixen or use the test function in XLights...
Then just use a meter or any sort of light to make sure the correct channels are activated....
zappedmyself.com