Hello all,
I just received my latest LE from the last coop. Got everything put together to the point of the heatsink. As I went to bolt it onto the board---the holes in the heatsink itself were not threaded properly. After speaking to RJ I realized that I had a work-around for the issue and he asked me to post it.
My very simple solution was a slightly longer M4 bolt (screw). I was going to use a nylock nut with it, but it grabbed just enough to hold the board on to the heatsink. Make sure you dont get real long bolts/screws as these will interfere with the nuts just above the mounting holes on the heatsink. I hope this works for anyone that may have issues.
Bryan
aka foody