Need setup verfication on DMX out

[aERonAUtical96]

Sorry... last minute change while setting up display... and thought about the dmx out 2 on a LE.

So my setup...

Dongle -> Freestyle -> LE #1 v4  --(DMX Out1)--> LE #2 v3
                                      |-- (DMX Out 2)--> LE #3 v3 -> LE #4 v4

Hard wired.  I am basically asking to use the DMX OUT 2 on LE #1 to LE #3.  I was going to run from LE #2 to #3 but my setup would be better fit with above.  I think I remember seeing that this will work with a wired setup.  In addition... I'm assuming that if this works that LEs #2 and #4 will need to have the terminate jumper in.

Search was giving me what I wanted to know.

Thanks.

[ThaiWay]

Rob you should be good to go.  From the Controller (Dimmers) Comparison Table on the Equipment page of the Wiki:  ** Two DMX outputs using wired input (Cat5) with ver 3 pcb and higher...

John

[RJ]

DMX OUT #2 is a useable output.

RJ