SSR4 board dimensions?

[CaptKirk]

I have access to a number of well pump control enclosures that I believe I could repurpose into water resistent SSR4 enclosures.  I do not have boards (yet - fingers crossed for a COOP this year) but I want my well guy to start saving burned out units for the cases for me if it will work.  What are the dimensions of a finished SSR4 width height and depth.  I think they are around 3x3x2 (with heat sync??) which would make the pump control box perfect (and FREE!!).  Thanks for the help.  Kirk

[rrowan]

Hi Capt

I measured 7.2cm x 7.9cm

Cheers

Rick R.

Sorry I missed the height I see about 2.5cm but that is tight I would give it more room.

[CaptKirk]

Thanks Rick,

Kirk

[gophergrove]

Why go there Capt???

[gforman]

That is going to be tight at best

2 7/8 by 3 1/8 plus wires

a little tight it would seem

[CaptKirk]

The well pump control box is about 4 1/2" inches wide by about 7" and around 4" deep so it sounds like it WILL work.   

If you are in a rural area, you might contact your local well guy as they replace these things ALL the time and end up throwing them out.  My guy gets a whole new control box and if a customer's is bad, he swaps out the lid (that contains the electronics like relay and start cap, etc.) so he ends up with old lids and new boxes.  I am using the 1/2 to 1 horse pump enclosure (the smaller one).

Hope this helps.

[dlhoppe]

Can you post pics?

[CaptKirk]

Found pics online