Author Topic: EX/RX non LE header  (Read 1244 times)

Offline shaunkad

  • Sr. Member
  • ****
  • Posts: 417
  • 44241
EX/RX non LE header
« on: March 29, 2011, »
Can this be purchased from mouser or is this a  PCB? There is no mention of it in the wiki and  I could not find it any where except the coops threads.

Offline rrowan

  • Administrator
  • Sr. Member
  • *****
  • Posts: 5899
  • 08096
Re: EX/RX non LE header
« Reply #1 on: March 29, 2011, »
Here is the wiki page

You are not allowed to view links. Register or Login

Cheers

Rick R.
Light Animation Hobby - Having fun and Learning at the same time. (21st member of DLA)
You are not allowed to view links. Register or Login
Warning SOME assembly required

Offline shaunkad

  • Sr. Member
  • ****
  • Posts: 417
  • 44241
Re: EX/RX non LE header
« Reply #2 on: March 29, 2011, »
You are not allowed to view links. Register or Login
Here is the wiki page

You are not allowed to view links. Register or Login

Cheers

Rick R.




Thank you, Rick

I did not think to look at the V1 page of the EX/RX page

Shaun

Offline jnealand

  • Patron Member
  • Sr. Member
  • ****
  • Posts: 2494
Re: EX/RX non LE header
« Reply #3 on: March 29, 2011, »
I would suggest adding a note to that wiki page.

RJ suggests that you get better reception if the antenna is pointing up.  When I did my SSRs I put them in the top with the antenna up, but when you close the case the antenna is pointing down.  I turned them around last season, but with one of them the wires were to short to do this and I had to desolder and put new, longer wires in place.  Not a big deal, but anyone starting from scratch could avoid this.
Jim Nealand
Kennesaw, GA