question about the two 1uf cap. which are very close on the tx pcb

[taybrynn]

Can the two 1uf caps which are very close ... can they be bridged (connected) to each other?

This is the top side view with an arrow showing the two points which appear bridged on my tx pcb.

My question is: should they be bridged, or should they be separate ?

After soldering up my first tx/rx ... I noticed that these appeared bridged and I tested them and they are
indeed connected / bridged.

My question is: is this ok?

Thx,
Scott / taybrynn

[RJ]

Sorry for the delay as I was at work all day.

Yes these two are connected in the middle so after soldering it will appear they are bridged.

RJ

[taybrynn]

Thanks RJ  !!