MR 16 Wireless?????

[mmais68569]

I do not see it in the BOM but can the MR 16 be run wireless with RJ's  units? Does the receiver solder direct to the PCB?

         Mike

[bisquit476]

Yes they can be wireless,

You are not allowed to view links. Register or Login

[mmais68569]

based on the 2 reply's the EX receiver DOES NOT connect direct to the board.
I have looked at the WIKI & am not very sure how this will work Does the 535-08-600-10 replace the replace the RS485 chip or do I need to solder this in place of the RS485 & then replace the chip on top. This is a learning year for this old man I am converting over from LOR so sorry for all the questions.

     

             Mike

[bisquit476]

Hi Mike,

There is a header that is required. You then solder the wires (RC controller wires off of Ebay, RJ recommended and they work great) to the header and to the EX/RX board in the holes shown in the picture, and your ready to go, have fun,

Bill

[RJ]

You unplug the chip and remove it and then plug the header in place of the chip.

RJ

[mmais68569]

Thanks RJ

   That is the simple answer I was looking for.

             Mike

[mmais68569]

What if I used a TX/RX wireless placed in a case & ran a Cat 5 cable from it to the MR 16 will that work?

              Mike

[rrowan]

What if I used a TX/RX wireless placed in a case & ran a Cat 5 cable from it to the MR 16 will that work?

              Mike

Yes, as long as the TX/RX is in RX mode

Rick R.

[mmais68569]

Thanks Rick