« previous next »
Pages: [1]

Author Topic: Problem with new lynx express  (Read 1133 times)

Offline wrxin

  • Jr. Member
  • **
  • Posts: 20
Problem with new lynx express
« on: October 31, 2011, »
This is my first lynx express. Just finished the assembly. The two LEDS (5 and 3.3) light up fine but I have a dimly lit number six LED and the display does not work. Pressing and holding reset turns off the number six LED but it dimly lights again when I release the button.

I have not programmed the chip yet.

I'd really appreciate any help.

Thanks
Logged

Offline KeithTarpley

  • Administrator
  • Sr. Member
  • *****
  • Posts: 1990
Re: Problem with new lynx express
« Reply #1 on: October 31, 2011, »
Greetings,,,

That should change for the better after you program the chip.

Keith
Logged
"Now I know the only foe is time." -Moody Blues

Offline barbotte

  • Sr. Member
  • ****
  • Posts: 242
Re: Problem with new lynx express
« Reply #2 on: October 31, 2011, »
make sure you look at your solder joint where the led are dim .. i had the same problem on 1 led ans i guess i had cold fusion as i re heat the defect joint and voila everything work flawless ... as i was told yesterday ... the chip were program by RJ so i don't think it is the chip program ...
Logged

Offline wrxin

  • Jr. Member
  • **
  • Posts: 20
Re: Problem with new lynx express
« Reply #3 on: October 31, 2011, »
Thanks for the help. I'll program the PIC and see how it goes.
Logged
Pages: [1]
« previous next »