Difference between revisions of "Equipment"
From DiyLightAnimation
m (Added links for Previous Manuals & BOMs for the LE and Dongle) |
m (→'''Dimmers''': Change format for previous manuals, change le picture to v4 was v3) |
||
Line 91: | Line 91: | ||
|<center>'''Lynx Express'''</center>[[Image:LE-CaseR.jpg|left|thumb|160px|16 Channel]] | |<center>'''Lynx Express'''</center>[[Image:LE-CaseR.jpg|left|thumb|160px|16 Channel]] | ||
− | *[[Manual Express|Manual]] [[Arch_LE| - Previous | + | *[[Manual Express|Manual v4]] |
+ | **[[Arch_LE| - Previous Manuals/BOMs]] | ||
* Assembly Videos | * Assembly Videos | ||
** [http://www.diylightanimation.com/Express_V4_Manual_Part_1.wmv Part 1] | ** [http://www.diylightanimation.com/Express_V4_Manual_Part_1.wmv Part 1] |
Revision as of 08:49, 4 February 2010
Contents
Hooking up a DMX Universe
- Hookup Diagrams showing DMX devices connected to a computer.
Equipment Errata
- This page is for mods needed on released production boards from DLA.
Controller (Dimmers) Comparison Table
Controller | DMX | # Channels | On Board SSR | Wireless Pkg | LNT | Dimming | On Board Splitter | 12v DC | 120v AC | 240 AC |
Lynx Express | Yes | 16 | Yes | EX/RX or RX | Yes | Yes | Yes (1)** | No | Yes | Yes |
Lynx Freestyle | Yes | 128 | No/SSR4 | EX/RX wMod or RX | No | Yes | No | No | Yes | Yes |
Lynx SSR4-DMX | Yes | 4 | Yes | EX/RX wMod or RX | No | Yes | No | No | Yes | No |
Lynx MR-16 | Yes | 16 | LED/MR16 | EX/RX wMod or RX | No | Yes | No | Yes *** | No | No |
- Legend
- LNT = Light Normalizing Technology. With the proper curves all lights turn on and dim at the same rate.
- Need to know if Lynx hardware works in your region? Lynx Voltage Info
- Asterisk Notes
- ** Two DMX outputs using wired input (Cat5) with ver 3 pcb and higher or
- One DMX output (DMX Out2) if using the mounted EX/RX wireless module on ver 3 pcb and higher
- *** MR16 is capable of handling up to 24 volt DC source power. Please place a heat sink on the 5 volt regulator.
|
|
|
|
|