Difference between revisions of "Equipment"
From DiyLightAnimation
m (→'''PixelNet''') |
m (→Pixelnet Hardware) |
||
Line 122: | Line 122: | ||
*[[Manual v1]] | *[[Manual v1]] | ||
*[ Mouser Direct] | *[ Mouser Direct] | ||
+ | *[ Firmware] xxxx | ||
|} | |} | ||
---- | ---- |
Revision as of 21:07, 11 January 2011
Contents
Hooking up a DMX Universe
- Hookup Diagrams showing DMX devices connected to a computer.
Equipment Errata
- This page is for mods needed on released production boards from DLA.
Controller (Dimmers) Comparison Table
Controller | DMX | # Channels | On Board SSR | Wireless Pkg | LNT | Dimming | On Board Splitter | 12v DC | 120v AC | 240 AC |
Lynx Express | Yes | 16 | Yes | EX/RX or RX | Yes | Yes | Yes (1)** | No | Yes | Yes |
Lynx Freestyle | Yes | 128 | No/SSR4 | EX/RX wMod or RX | No | Yes | No | No | Yes | Yes |
Lynx SSR4-DMX | Yes | 4 | Yes | EX/RX wMod or RX | No | Yes | No | No | Yes | No |
Lynx MR-16 | Yes | 16 | LED/MR16 | EX/RX wMod or RX | No | Yes | No | Yes *** | No | No |
- Legend
- LNT = Light Normalizing Technology. With the proper curves all lights turn on and dim at the same rate.
- Need to know if Lynx hardware works in your region? Lynx Voltage Info
- Asterisk Notes
- ** Two DMX outputs using wired input (Cat5) with ver 3 pcb and higher or
- One DMX output (DMX Out2) if using the mounted EX/RX wireless module on ver 3 pcb and higher
- *** MR16 is capable of handling up to 24 volt DC source power. Please place a heat sink on the 5 volt regulator.
Cases Chart
Lynx Device | Case Part# | Info | Purchase Info |
|
CG-1500 | Coax Demarcation Enclosure
|
|
16 Channel DC Controller |
CG-500 | Coax Demarcation Enclosure
|
|
|
TA-200 | Coax Demarcation Enclosure
|
|
|
LP-35P | Choose Gray and put in the comments of the order
|
If you call they will ship USPS at a much cheaper rate than UPS |
|
LP-51P | Choose Gray and put in the comments of the order
|
If you call they will ship USPS at a much cheaper rate than UPS |
PixelNet
Pixelnet Library
Documents | PixelNet Specification | Smart String Power Requirements | Smart String Node Documentation |
Videos | Smart String Demo 1 | Smart String Demo 2 | Waterproofing Nodes |
Diagrams |
Pixelnet Hardware
|
|
|
Aether
DMX LED RGB(W) Flood/Spot Light
Pronunciation on Aether: Ether \E"ther\ ([=e]"th[~e]r), n. [L. aether, Gr. a'iqh`r, fr. a'i`qein to light up, kindle, burn, blaze; akin to Skr. idh, indh, and prob. to E. idle: cf. F. ['e]ther.] [Written also [ae]ther.]
|
|
||
Parts Ordering: Mouser Direct Order (1) of this part PCB from RJ |
|
|