Difference between revisions of "Equipment"
From DiyLightAnimation
(→'''Controller Comparison Table''') |
|||
| Line 74: | Line 74: | ||
| LNT Support | | LNT Support | ||
| Yes | | Yes | ||
| − | | No | + | | No |
| − | | No | + | | No |
| No | | No | ||
|- | |- | ||
| Line 95: | Line 95: | ||
| Wireless Support | | Wireless Support | ||
| Under development | | Under development | ||
| − | | | + | | No |
| − | | | + | | No |
| − | | | + | | No |
|} | |} | ||
| − | Note: Amperages are estimates only. These units are | + | Note: Amperages are estimates only. These units are for personal use ONLY. Not commercially tested or listed (e.g. UL). |
Legend | Legend | ||
Revision as of 19:21, 1 March 2009
Contents
Hooking up a DMX Universe
- Hookup Diagrams showing DMX devices connected to a computer.
Equipment Errata
- This page is for mods needed on released production boards from DLA.
Controller Comparison Table
| Lynx Express | Lynx Freestyle | SSR4 W/DMX | MR16 | |
|---|---|---|---|---|
| DMX | Yes | Yes | Yes | Yes |
| Channels | 16 | 128 | 4 | 16 |
| Supports Dimming? | Yes | Yes | Yes | Yes |
| Input Power | 120/240VAC 50/60Hz | 120/240VAC 60 Hz | 120VAC 60 Hz | 12VDC |
| Onboard SSR | 16 - 120/240VAC | None | 4 - 120/240VAC | 16 - 12VDC |
| Max Amps Out Total | 40 with dual input, 20 with single input | N/A | 8 | 35 |
| Max Amps Out / Channel | 3 with heat sink, 1-2 without | N/A | 2 with heat sink, 1 without | 2.5 |
| LNT Support | Yes | No | No | No |
| On-board start channel programming | Yes | No | No | No |
| DMX Splitter | Yes, 2 out total | No, 1 out total | No, 1 out total | No, 1 out total |
| Wireless Support | Under development | No | No | No |
Note: Amperages are estimates only. These units are for personal use ONLY. Not commercially tested or listed (e.g. UL).
Legend
- LNT = Light Normalizing Technology. With the proper curves all lights turn on and dim at the same rate.
- Need to know if Lynx hardware works in your region? Lynx Voltage Info
 |
 |
 |
 |
 |
 |
 |
 |
 |
