Here is my setup. etd with conductor using 8mb flash card from coop. feeds pixelnet to an active hub with 11 SSCs. Universe 1 DMX is output to the rest of my system. I have loaded the card with 32 sequences generated with xLights and LOR. 30 ogg songs as two of the sequences are only animation, no music. I created three shows: startup, main and shutdown. Startup and shutdown only have one sequence. Main has all 32 sequences that take 1 hour. I have setup a schedule for everyday. startup runs at 17:59 and lasts just shy of 1 minute. Main then plays from 18:00 to 22:00 and I have it repeating. Shutdown then plays at 22:00.
Startup begins fine at 17:59. Main then begins at 18:00 but for some reason cuts off about 10 mins before top of the hour and cancels the repeating show. display panel shows next show to play is shutdown at 22:00 but it is only 18:50. If I start another show, it cuts off at the same song.
I have tried three etd/conductor setups. Three different CF cards. They all do exactly the same thing. using the v69 conductor firmware and v3 control panel. I can connect through my network to the etd. I have looked at the other messages on the forum but have not seen anything like I am seeing, although, I have tried all solutions presented.
Having to revert back to my PC to run my show. Would appreciate any help you can suggest.