Earlier Keith posted a link to a CF socket. It looks like the same one on the board
You are not allowed to view links.
Register or
LoginI would try that route first. If it is the same part, then the soldering points will match up. If you use a card reader, then you will probably end up soldering a bunch of tiny wires and you will have to figure out some way to mount it.
Caretaker is right, it looks like a very difficult job. I've had to resolder all 4 sockets on my conductors and slaves and that was a beast. In those cases I didn't have to worry about the alignment of the pins during soldering because the tabs in the front were soldered down. If you do attempt it, make sure you have a pen of no-clean liquid flux, desoldering wick, and a good magnifier.