So I've been working on setting up my DMX channels in LSP.
I'm running the following:
1. Latest Light Show Pro
2. Etherdongle set up as E1.31 (Wirelessly from Laptop to ethernet hub, dongle connects to Hubs via ethernet flashed for Pixelnet)
3. Two 16 Port Active Hubs
4. Various LED Flexstrips
5. Two AC16 D-Light Controllers (now running DMX since I changed out the chips to allow me to address them as DMX controllers)
The problem I've having is getting the AC16's set up in LSP
I've set them up like this:
1. Hub one set up for PixelNet address jumpers 1 and 1, DMX jumper set to 8 (because my AC16's appear as channels 3898-3929)
2. Hub two set up for Pixelnet address jumpers 2 and 2, DMX jumper set to 1
3. FlexStrips are set up (and programmed for) with different addresses, from 1 to 3897
4. First DMX AC16 is programmed address starting at 3898 and end address 3913 (e.g. 16 channels)
5. Second DMX AC16 is programmed address starting at 3914 and end address 3929
Now, if I set it up this way, it doesn't work in LSP.
I can set the AC16's as lower channels numbers (e.g 1st AC16 to channel 1-16, and 2nd AC16 to channel 17-32)
and it works in LSP, but my LED light strips get screwed up, because the first Flexstrip is 120 nodes, so it's address is in the same range (e.g. Channel 1 to channel 360)
What am I doing wrong?
Any ideas how it should be set up correctly?